Alesis M1 Active 520 USB Monitors (pair)

ALESIS M1 ACTIVE 520 USB

Powered Speakers and USB studio interface

M1Active 520 USB is a studio monitoring system designed for professional studio use with an internal digital-audio interface. M1Active 520 USB is a pair of active, bi-amplified, two-way reference monitors that play from 20,000 Hz all the way down to 56 Hz to cover nearly all frequencies audible to human ears.

You can take USB digital signal out of your computer via USB and input it to M1Active 520 USB for low-noise, low-distortion performance. Priced attractively for any studio's budget, M1Active 520 USB perform with linearity, clarity, and neutrality typically reserved for monitors that cost much more.

EXTENSIVE I/O
Professional quality analog input jacks are located on the rear. Two balanced-1/4" inputs enable engineers to connect a stereo source or two mono sources. For convenient recordings, simply connect the stereo output of a mixer. You can create complete recordings with no additional audio interface!

USB DIGITAL AUDIO INTERFACE
In addition to their capabilities as traditional monitor loudspeakers, M1Active 520 USB monitors contain a USB audio interface. Connected audio sources such as mic preamps and instruments can be recorded directly into your computer at 16-bit, 44.1 or 48 kHz. Simply plug the USB cable into your computer. No special drivers required. And when it's time to listen back to your mixes, that same USB cable sends 16-bit, 44.1 or 48 kHz, stereo audio from computer to your M1Active 520 USBs. No more complicated interfaces and messy cable tangles.

Alesis M1 Active 520 USB Features Include:

- Low-frequency driver: 5” lightweight, magnetically-shielded, ultra-stiff polypropylene cone with rubber surround and high power handling voice coil
- High-frequency driver: one-inch silk dome with magnetic shielding
- Frequency Response: 56 - 20,000 Hz
- Power: 30 W per channel RMS
- Signal-to-Noise Ratio: >90dB weighted
- Digital Conversion: 16-bit delta sigma, 44.1kHz or 48kHz sampling rate
- Inputs: two balanced-1/4”
- Polarity: Positive signal on “+” pin creates forward cone displacement
- Input Impedance: 10k ohms
- Input Level: -10dBV nominal, balanced
- Dynamic Range: >80dB

A Fantastic and Easy to use pair of Speakers, Plug USB into your Laptop and your Ready to Mix!